Boot method: USB
Image version:  "Bookworm" - Unofficial amd64 NETINST with firmware
20211223-09:01
Date: <Date and time of the install>

Machine: motherboard  PRO Z690-A WIFI (MS-7D25)
Partitions: <df -Tl will do; the raw partition table is preferred>


Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot:           [O]
Detect network card:    [E]
Configure network:      [ ]
Detect media:           [ ]
Load installer modules: [ ]
Clock/timezone setup:   [ ]
User/password setup:    [ ]
Detect hard drives:     [ ]
Partition hard drives:  [ ]
Install base system:    [ ]
Install tasks:          [ ]
Install boot loader:    [ ]
Overall install:        [ ]

Comments/Problems:

The board has  Intel Corporation Ethernet Controller I225-V (rev 03). Hardware-
detection of that crash the system (mouse freeze, no reaction of all). Hard-
poweroff is the only way to end the process. After I disabled the netword-card
in BIOS and use a usb-netcard instead of that the installation works fine. Than
I can reenable I225-V in BIOS and the network over that works too.