Boot method: network
Image version: https://d-i.debian.org/daily-images/arm64/20220624-02:19/netboot/netboot.tar.gz
Date: 2022-06-24 after breakfast but before lunch
Machine: Solidrun Honeycomb LX2
Partitions:
udev devtmpfs 32513604 0 32513604 0% /dev
tmpfs tmpfs 6514616 744 6513872 1% /run
/dev/sda3 ext4 9510080 1530260 7475144 17% /
tmpfs tmpfs 32573080 0 32573080 0% /dev/shm
tmpfs tmpfs 5120 0 5120 0% /run/lock
/dev/sda1 vfat 389904 3536 386368 1% /boot/efi
tmpfs tmpfs 6514616 0 6514616 0% /run/user/1000
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [E]
Configure network: [O]
Detect media: [O]
Load installer modules: [O]
Clock/timezone setup: [O]
User/password setup: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Install base system: [O]
Install tasks: [O]
Install boot loader: [E]
Overall install: [E]
Comments/Problems:
On-board ethernet is not detected in debian-installer or even once the
system is installed. Worked around with a USB-ethernet adapter.
Boot loader would install successfully, but grub would not boot when I
had a system with rootfs on lvm on raid1 (with degraded 1-disk
array). I think this sort of configuration used to work, but it has
been ages since I've tested. Will check another install if it works
better with a not degraded array (e.g. raid1, two disks). Workaround
was to use a plain partition with ext4 for rootfs.
FWIW, Same issues with bullseye's installer too, so at least it's
not... a regression? :)
live well,
vagrant