#1019569 Installing with USB, don't use USB3 port.

Package:
installation-reports
Source:
installation-reports
Submitter:
KNE
Date:
2022-09-12 09:27:03 UTC
Severity:
normal
#1019569#5
Date:
2022-09-12 08:47:33 UTC
From:
To:
Boot method: USB stick to Network
Image version: debian-11.5.0-amd64-netinst.iso <https://cdimage.debian.org/debian-cd/current/amd64/iso-cd/debian-11.5.0-amd64-netinst.iso>
Date: Sep 12 2022 1am

Machine: Asus
Processor:
Memory:
Partitions: <df -Tl will do; the raw partition table is preferred>

Output of lspci -knn (or lspci -nn):

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot:           [o]
Detect network card:    [o]
Configure network:      [o]
Detect media:           [0]
Load installer modules: [0]
Detect hard drives:     [o]
Partition hard drives:  [o]
Install base system:    [e]
Clock/timezone setup:   [ ]
User/password setup:    [ ]
Install tasks:          [ ]
Install boot loader:    [ ]
Overall install:        [ ]

Comments/Problems: don’t know if this has been mentioned or not, but while trying install the USB kept changing mount points, it started at sdg,sdh,sdi all the way up to sdo, which would error the install. Install kept saying to put the install media into /media/cdrom.  I finally figured out that the USB was plugged into a USB3 slot, once I moved it to a regular USB the install worked great.
#1019569#10
Date:
2022-09-12 09:19:14 UTC
From:
To:
Hello,
(...)

These are device names, not mount points.

Sounds like a xHCI driver/controller/port/connector/stick issue causing
endless disconnects/reconnects. Please check the kernel logs.