Hello,

this is my first trixie install. I had to configure the network manually due to the configuration of the VM host. I did a typo in the DNS IP Address (fec0:0:0:fff::1 instead of fec0:0:0:ffff::1). That ended up in /etc/resoolv.conf in the target system and of course made the installation of additional packages fail. I then backed up to the network configuration and fixed the issue, and was faced with the installation of additional packages failing again. Inspecting on the shell turned out that /etc/resolv.conf in the installer got fixed, but /target/etc/resolv.conf still had the wrong address. I used an editor to fix /target/etc/resolv.conf and was able to continue installing.

Greetings
Marc

Boot method: CD
Image version: debian-13.0.0-amd64-netinst.iso downloaded 2025-08-10
Date: <Date and time of the install>

Machine: KVM VM on unstable, UEFI
Partitions: <df -Tl will do; the raw partition table is preferred>


Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot:           [ ]
Detect network card:    [ ]
Configure network:      [ ]
Detect media:           [ ]
Load installer modules: [ ]
Clock/timezone setup:   [ ]
User/password setup:    [ ]
Detect hard drives:     [ ]
Partition hard drives:  [ ]
Install base system:    [ ]
Install tasks:          [ ]
Install boot loader:    [ ]
Overall install:        [ ]

Comments/Problems:

<Description of the install, in prose, and any thoughts, comments
      and ideas you had during the initial install.>


Please make sure that any installation logs that you think would
be useful are attached to this report. (You can find them in the
installer system in /var/log/ and later on the installed system
under /var/log/installer.) Please compress large files using gzip.