#992774 installation-report

Package:
installation-reports
Source:
installation-reports
Submitter:
lucas
Date:
2021-08-23 15:33:02 UTC
Severity:
normal
#992774#5
Date:
2021-08-23 08:59:16 UTC
From:
To:

Boot method: Flashing eMMC

Image version: https://raspi.debian.net/verified/20210718_raspi_4_bullseye.img.xz

Date: 20-08-2021, 15:08

Machine: Raspberry Pi Compute Module 4 IO Board

Processor: Broadcom BCM2711 quad-core Cortex-A72 (ARM v8) 64-bit SoC

Memory: 8GB SDRAM

Partitions: not possible



Output of lspci -knn (or lspci -nn):not possible



Base System Installation Checklist:

[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it



Initial boot:           [ ]

Detect network card:    [ ]

Configure network:      [ ]

Detect media:           [ ]

Load installer modules: [ ]

Detect hard drives:     [ ]

Partition hard drives:  [ ]

Install base system:    [ ]

Clock/timezone setup:   [ ]

User/password setup:    [ ]

Install tasks:          [ ]

Install boot loader:    [ ]

Overall install:        [ ]



Comments/Problems:

Installation was successful except for disabled usb port. Documentation for hardware (Raspi Compute Module 4) states usb ports disabled

 by default and provides a method to enable them at boot with raspian config.txt . The same method does not work with this Debian image.
#992774#10
Date:
2021-08-23 13:00:21 UTC
From:
To:
Hi,

lucas <mclucas44@live.co.uk> (2021-08-23):

Thanks for your report. FWIW we deal with installations that were
performed using the Debian Installer; I'm putting the maintainers of the
relevant Raspberry Pi tooling in copy.

You didn't need any extra DTB to get your CM4 to boot? Or did you skip
mentioning extra steps regarding the deployment of the raspi.debian.net
provided image?


Cheers,
#992774#15
Date:
2021-08-23 15:28:59 UTC
From:
To:
Hi Cyril,

Appreciate the swift response, hopefully the raspi team can help.

No other steps were needed just wrote the image to the eMMC with balena and plugged it in.

Thanks again,
Lucas


Thanks for your report. FWIW we deal with installations that were
performed using the Debian Installer; I'm putting the maintainers of the
relevant Raspberry Pi tooling in copy.

You didn't need any extra DTB to get your CM4 to boot? Or did you skip
mentioning extra steps regarding the deployment of the raspi.debian.net
provided image?


Cheers,
--
Cyril Brulebois (kibi@debian.org)            <https://debamax.com/>
D-I release manager -- Release team member -- Freelance Consultant